Amerlock 2 VOC
Product Data/Application Instructions:
Amerlock 2 is a fast-drying, surface-tolerant, VOC-compliant two part epoxy.(mixed 1:1) It has a low-temperature cure (down to 0F), dries to touch in two hours, and can be recoated in three hours. It offers exceptional corrosion protection in industrial and marine corrosive environments. Amerlock 2 adheres well to tight rust and prepared damp surfaces, and makes a self-priming topcoat over most existing coatings. Its low solvent level meets VOC requirements and reduces the chances for film pinholing and solvent entrapment at the substrate-coating interface. It is designed for use in a variety of areas, even those where surface preparation is impossible. It has a good chemical resistance to splash/spillage, fumes and immersion in neutral, fresh and salt water.
• Fast dry, dry to touch in 2 hours at 70F (21C)
• Recoat in 3 hours at 70°F (21C)
• Lowtemperature cure down to 0F (-18C)
• Exceptional corrosion protection in industrial andmarine corrosive environments
• Surface tolerant, excellent adhesion to tight rust and prepared damp surfaces
• Self priming topcoat overmost existing coatings
• Can be overcoatedwith awide range of topcoats
• Meets all existing VOC regulations including SCAQMD Rule 1113 requirements
•Temperature resistance to 450°F on insulated or uninsulated surfaces when mixed with Amercoat 880 glass flake additive.
Amerlock 2 VOC’s low solvent level meets SCAQM (Southern California Air Quality Management) VOC requirements,reduces the chances for filmpinholing and solvent entrapment at the substrate-coating interface, often a major cause of coating failure with conventional epoxies and lower solids systems. Amerlock 2 VOC is available in a variety of colors, and therefore does not require a topcoat. For extended weatherability or special uses, a topcoatmay be desired.
Typical Uses:
Amerlock 2 VOC’s is designed for use in a variety of areas, even those where surface preparation is impossible. As a maintenance coating, Amerlock 2 VOC protects steel structures in industrial facilities:
• bridges,
• tank exteriors,
• marineweathering,
• offshore,
• oil tanks,
• piping,
• roofs,
• water towers and other exposures.
Amerlock 2 VOC’s has good chemical resistance to splash/spillage, fumes and immersionin neutral, fresh and saltwater (see resistance table).
Qualifications (Amerlock 2 VOC):
USDA – Incidental food contact
NFPA – Class A
For a complete product data sheet and MSDSs please contact us.
For Product delivery greater than 60 miles from the San Fernando Valley California please contact us for shipping information
