Description:
Axalta Imron® Industrial Strength is the next generation of Imron® technology. Based upon patented formulations and resin technology, Imron® Industrial Strength is the fastest Imron® yet, with the lowest environmental impact. Imron® Industrial Strength Low VOC Polyurethane Primer is a durable, fast dry, high solids, two- package, VOC conforming, 0.8 lbs/ gal, for most conditions, low HAPS product based on Axalta polyurethane technology, producing an acrylic polyurethane primer which can be brushed, rolled or sprayed. The resulting product delivers high performance and provides a smooth surface for maximum topcoat appearance.
Suggested Uses:
As a high performance, tough, industrial strength polyurethane primer over properly prepared aluminum, carbon steel, galvanized or fiberglass where:
• A smooth primer will provide maximum topcoat appearance
• Low VOC and HAPS will reduce the environmental footprint
• Application by brush, roll or spray is desired
• Outstanding flexibility is needed
• Faster dry times are desired
• Wet on wet applications
• Application down to 35°F
Activation:
Thoroughly mix all colored portions until uniform. To 8 parts 9PXX Primer base, add one part Imron® 9T00-A™ Activator. Measure out appropriate amounts, add activator and mix thoroughly. For most applications, add 10— 15% Imron® 9M01™, 9M02™ or T-1022™ reducer depending upon application conditions and methods. Mix until uniform. (See reduction section below.) Mix thoroughly using a mechanically powered sheer “Jiffy” mixer with variable RPM settings; use medium speed RPM. Move mixer up and down through paint for uniform mixing. DO NOT SHAKE. Note: Upon activation of 8:1 with 9T00-A™ Activator, the mix produces 1.125 gallons. 1 full gallon of 9PXX Primer Base to 1 pint (0.125 gal) of activator for a total of 1.125 gallons.
Not recommended for:
Immersion service
Compatibility with Other Coatings:
Imron® Industrial Strength Primer can be top coated with other Axalta Industrial Coatings including, but not limitedto: Imron® Industrial Strength Top coatts, Imron® 2.1
Imron®Industrial Strength Primer may be used over most aged and hard-cured coatings in good condition.
Testing for lifting, bubbling and adhesion is recommended to assure compatibility with unknown coatings.
Contact your Annex paint tech Rep for specific recommendations
MSDS's are available upon request.
For Product delivery greater than 60 miles from the San Fernando Valley California please contact us for shipping information
