Centurion 275 Water Clear Vinyl Sanding Sealer
CS-2007
Product Description:
High solids, high build, vinyl modified nitrocellulose sanding sealer for wood. Vinyl sealers are general used Fast build • Fast Drying • increased moisture resistance from vinyl modification
Recommended Usage:
General Purpose interior Applications • Interior Doors • Kitchen Cabinets • Interior Shutters & Moldings
Application:
Application Method:
May be sprayed with conventional, airless and air assisted-airless application equipment.
Mixing Instructions:
Ready to Spray. May be reduced as needed with Acetone, retarder or preferred lacquer thinner.
Substrate Preparation:
The surface must be clean, dry and free of grease, oil, dirt, fingerprints and any othercontamination to ensure proper adhesion. Remove any loose or peeling paint. Sand basecoat with 320-400 grit sandpaper. May be applied over acrylic, nitrocellulose and UV Basecoats.Test for adhesion and compatibility before full scale application.
Application Instructions:
Mix well using a power agitator prior to application. On application, the temperature of theproduct, substrate and coating should be above 50 • F. Apply up to 3 coats, allowing sufficient drying time between coats.
Coverage:
Approximately 285 square feet per gallon at 1 dry mil. Actual coverage may vary depending on application technique, equipment and weather conditions. Safety/ Clean Up: Please read MSDS and product label before using. Applications tools must be cleaned with water after use. Dispose of any leftover coating in accordance with local, state or federal regulations.
Additional Notes:
Reduce and clean with Acetone.
Physical Properties Curing/Drying Time Properties
Vehicle Type Coconut oil plasticized nitrocellulose/vinyl
Air Drying Time [17° F 50% humidity)
Solids by Volume 17.15 (+/-1%) Dust Free 10-15 minutes
Solids by Weight 24.68 (+/-1%) Sand 20·25 minutes
voc Less than 275 g/I Package 4-6 hours
Viscosity 33-35 sec. Zahn # 2 Flash-off 10minutes
Specific Gravity .845
Force Dry Time
No more than 120°F 20·30 minutes/package in 2-4 hours
For Product delivery greater than 60 miles from the San Fernando Valley California please contact us for shipping information
You can also visit our library of references and helpful tips at our wood finishing Blog at: www.woodfinishings.wordpress.com
