Centurion™ 275 White Vinyl lacquer Undercoater
CS-1106
Product Description:
High solids, high build, non-stearated, vinyl modified white nitrocellulose primer/undercoater for
wood. The vinyl modification, increases the moisture resistance of the cured film.
Main Properties:
Fast build Fast Drying Sands great, no build up on sand paper
Recommended Usage:
General Purpose interior Applications Interior Doors Kitchen Cabinets Interior
Shutters & Moldings
Application:
Application Method: May be sprayed with conventional, airless and air assisted-airless application equipment.
Mixing Instructions: Ready to Spray. May be reduced as needed with Acetone, retarder or preferred lacquer thinner.
Substrate
Preparation:
The surface must be clean, dry and free of grease, oil, dirt, fingerprints and any other
contamination to ensure proper adhesion. Remove any loose or peeling paint. Sand basecoat
with 320-400 grit sandpaper. May be applied over acrylic, nitrocellulose and UV Basecoats.
Test for adhesion and compatibility before full scale application.
Application
Instructions:
Mix well using a power agitator prior to application. On application, the temperature of the
product, substrate and coating should be above 50 º F . Apply up to 3 coats, allowing sufficient
drying time between coats.
Coverage: Approximately 350 square feet per gallon at 1 dry mil. Actual coverage may vary depending on
application technique, equipment and weather conditions.
Safety/ Clean Up: Please read MSDS and product label before using. Applications tools must be cleaned with
water after use. Dispose of any leftover coating in accordance with local, state or federal
regulations.
Additional Notes: Reduce and clean with Acetone.